The rear brake set up, handbrake cables mounted to the lever asembly, the rear disc bracket mounted tot he rear hub ( this can only fit one way to line up with all four holes in the hub carrier)

 

The handbrake cables are clamped with solderless nipple to a mounting plate, with a threaded bar with clevis pin to the brake lever.

 

To adjust the lever, i pulled up the handbrake lever 6 clicks then took up the slack on the cable adjuster where they pass into the rear section of chassis, then wound them untill the rear brakes binded.

 

To get the disc in the centre or the caliper a ‘1mm’ washer was placed on each wheel stud to centre the disc.